swingarm question?

[under1]

i like to know:icon_susp how thick the drive shaft rod is(inside swingarm)if someone can help me,i dont want to take mine :icon_buil aprt yet,,workin on arm mod:stirpot: thanks for the info,,,,,,peace out:patriot:

[Green Ghost]

I just had mine ouy but I didn't measure it. If I had to guess on the diameter I would say it was 23 to 25 mm. Just think of the front or rear axle size. The driveshaft is very close to the 25mm. And it tapers in the front with the splines that go inside the yoke joint. Hope this helps. If I would have seen this post yesterday I would have told you for sure. GG :D