????load equalizer???????

[bleck]

I just recieved kury mini bullets today and in the directions it says you need to add a load equalizer for them to function as rear turn signals only. Is this so, and if I need to get one, do you know the kuryakyn part #. Please any help wouuld be great. Want to get back on the road as soon as possible. Thanx.

[jdt3]

You can get a heavy duty flasher and it will work also go to clearalternatives.com I think you can get one from them your lights will blink real fast without one or the other but it wont hurt anything to runn like that until you get what you need. You might try an auto part store for the flasher also. Take yours out and see if they can match it up. God Luck

[bleck]

Hey thanx. I have them all mounted, but didn't wire them yet because I didn't want to hurt anything. Guese I'll order the equalizer, wire them up, and ride around untill it comes to may door. Thanks again.

[need4speed]

Show Chrome sells a digital flasher that is a plug and play replacement for the OEM flasher. The part number is 13-306.

[razorbak57]

Hey bleck not trying to steal your thread but here goes. I have the mini bullets on front and rear. Also have 2 kury equalizers. Am having hell trying to wire them in. Directions really suck (i'm also not good with wiring ). Sure could use some help what color goes where for front and back.

[razorbak57]

http://www.xtremerevolution.com/Store/spc-1104-28-1-kuryakyn-load-equalizers.aspx. Here's what your looking for bleck.

[need4speed]

You will need to cut the white plug from the end. I think that you should only need one and not two. Most Honda Cruisers only need one but Yam/KAW/SUZ need two. To install one you can go under the right side cover. Splide the two violet wires from the load equalizer into the blue and orange wires (turn signal wires) and splice the black wire into one of the green ground wires (not the brake wire). At this point your turn signals should flash at the stock rate.

If they do not remove the headlight to expose the front turn signal wires. Splice the two violet wires into the orange and blue wires and the black wire into the green ground wire. Your turn signals should now flash at the stock rate. As a note, the running light wires to the front turn signals will also be orange and blue but will have a white stripe on them.

[razorbak57]

Thanks alot, I'll try it tomorrow night andk let you know. Thanks again.