clutch

Hi, 2006 VTX1300R. This is my daily. Without prior indication of troubles, I got on the bike and started out to work. Can't get it to shift into 3rd. 1st is good, neutral is fine, 2nd is a little rough engaging, but it goes. 3rd will not happen. Parked it back in garage and took the car...

Hi, I have an '06 VTX1300R. When the clutch is let out a little quick it makes an awful waaaaaahhhh noise for about 1 sec. I am thinking it may be time to give the clutch attention. Although, after the first few seconds or feet and if the clutch is let out slower there is no noise. If I give...

Replaced VTX1800 clutch is STILL slipping. Bike can sit in gear with lever released and it just sits there. Revving the engine will produce VERY LITTLE movement. Back story. Bike sat for a couple years (previous owner died so I have no history). Owners brother drove it the day before I got...

I've posted this a couple other p[laces, so if you've seen this before, I apologize. I would be enormously grateful to anyone that can have some productive insight on my clutch issue. It's been going on for almost 5 years now and I'm at a loss. I have a 2003 VTX1800S. It's right bout at 20k...

I have a 2003 VTX1800 and I'm on my 4th clutch with only 17.5k on the odometer. I'm starting to believe the clutch isn't the problem, but I'm at a loss as to where to turn. I PRAY someone here has an idea or two. Clutch 1 - Original Clutch from Honda. Lasted to about 13k. Started slipping and...

Prepping 2004 1800 N for ride. Fired it up in N, hopped on, depressed clutch & brake, retracted kick stand, dropped it into first & the bike lurched forward & stalled. Was not expecting that as I was still depressing the clutch. Checked it again & did same thing. Does not appear that the...

Here is the sad long story short...have not ridin in over two years because of three shoulder surgeries. I think I am ready to take a few short rides to see how I do but my clutch is out. So I bought the kit and started to work on it so I could ride this weekend. I am rebuilding the clutch...

I have a Kuryakyn Clutch Perch Cover I'd like to sale for $20 (plus shipping). I've had it for about 9 months and it is in like-new condition. Pics are below. The reason I'm selling it is because I bought CP Punisher handlebars and this no longer fits. I have a PayPal account and live in the...

This noise is random. It seem to be in the engine, because it happens when I give it a quick shot on the throttle. It goes away when cruising with no load ( accel/deccel). Stops if I pull the clutch to disengage. Sometimes a very short duration some times not. Thanks in advance Duncan

Hi All, Need a little advice, pls. '04 VTX1300C - replaced the clutch cable. Noticed that the nut on the bottom of the clutch lever assembly was loose. Also saw that the bolt thru the assy turns when the lever is pulled and released. Tried to get the bolt out, but no luck, and didn't want...

VTX 1300 C, R, S and T right crankcase cover. New. New in a box. Honda part # 11331-MEA-671. May fit other models. Check with an expert. Fits Honda models: 2004 S and C. 2005 C, R and S. 2006 C. 2007 R and S. 2008 C. 2009 R and T. Aluminum crankcase cover only. I have a chrome plastic clutch...

OK so I am a newbie. I hope someone can point me in the right direction. 2003 VTX1300s, 8600 miles Starts up normally. When I shift into first gear to go, no acceleration at all when I ease off clutch, same for second gear. Matter of fact, when I release clutch lever in gear (not moving)...

I got a little careless and took a chunk out of my clutch cover. Would like to pick one up if anyone has one from a doner bike. Thanks!

I'm in the process of chroming out everything on my handlebars...controls..etc. I ordered the kury chrome brake/clutch levers, but was wondering what to do about the actual brackets they mount into. So far all I found was this...

I recently took my bike out for a quick ride. I noticed that every time i let the clutch out the bike would putter like it was getting no fuel. I have to give it a lot of throttle to keep the bike from dying. I just emptied all the gas from the tank and put brand new fuel in it. The bike has...

I can not get my VTX1300C to start/crank over when it is in gear with the kickstand up. The kickstand works because it will stall if I put it down when in gear. I tested the clutch switch and it works fine. The odd thing is that the power source for the switch (coming from the start relay) only...

Hello, I am looking for both master cylinders (Clutch and front brake) from a VTX1800. I am looking to replace the handlebars on my 1994 VT1100c and the existing master cylinders are angled to fit the stock buckhorns but don't look right on straighter handlebars They don't need to be...

I am in need of a right rear clutch cover for a 2003 Honda VTX 1800C. My current one was slightly dented due to a fall. I have tried to price this part on the internet, however, I don't believe that I'm finding the exact part that I am in need of. I've listed a link below to a parts website in...