Honda VTX 1300 / VTX 1800 Motorcycles Forum banner
grips
1-5 of 6 Results
  1. Honda VTX 1300 Forums
    Was just about done installing Baron bars and new Kuryakyn ISO grups on my 2009 vtx1300r when I ran into an issue. When re-installing the throttle, there doesn't seem to be enough slack to connect both throttle cables to the throttle tube/sleeve. I have gotten as much slack possible from the...
  2. Honda VTX 1800 Forums
    I just recently purchased a new set of Kuryakyn ISO grips p/n 6240 from ebay and I went to put them on my VTX 1800 C with the Barons xtreme bar (stock grips from original bar) on it and the grips don't seem correct.... What I mean is that when I took off the clutch grip and slid the new grip on...
  3. Honda VTX 1300 Forums
    Installed avon grips on my 1300 vtx and I can't quite get the throttle to snap back like it should. I tried the adapter for Honda and the other models and neither seem to work. Any ideas? I'm getting really tired of installing and removing the throttle cables.:banghead:
  4. Honda VTX 1300 Forums
    Hey everyone! I hope you're all enjoying the closing months to what is the normal riding season (at least here in Indiana). Personally, I ride year around unless there is snow or ice on the roadways. I recently had some mods on my ride and wanted to share a few pics. I had the stock bars...
  5. Honda VTX 1300 Forums
    I attempted to install my new grips from Avon this weekend ( http://www.meancycles.com/Home.asp?PartID=216019&AccCategoryID=2301&AccCategoryTypeID=0&BikeModelID=5495&ManufacturerID=0&BikeType=Cruiser&CompanyID=0 ) And ran into a problem installing them. The actuator cam on the new grips was too...
1-5 of 6 Results
Top