[BMF572]

Anyone here used these before? If so anything good/bad as far as issues (ie mounting, performance, etc)? These are for a 1” bar. I’ve got a broken clutch lever and really don’t want to go back with the boring stock levers.

 

[Mr. Incredible]

You can buy just the levers and replace them.
While I’m not using that specific one. Yes i am using the generic aftermarket units, got them on ebay

I went with black that look like the boring OEM units because i couldn’t get new Honda units as they are on back order and have been since last November.

they seem to work just fine. The MC and related build kit is identical (on mine) to the factory units. My custom engraved covers from 2005 that were on the factory units fit perfectly,

In all honesty I can’t tell any difference to the OEM units other than mine were $70 for the set not $350.

And mine are black not silver.

 

[Mr. Incredible]

These are the ones I’m using.

Brake Clutch Master Cylinder Lever for Honda VTX1800 02-08 GL1500 VALKYRIE 97-03 | eBay

Honda VTX1800 2002-2008. Honda GL1500C (VALKYRIE/ F6C) 1997-2003. No installation instruction. Easy install andNo Modification Needed.

www.ebay.com

 

[BMF572]

These are the ones I’m using.

Brake Clutch Master Cylinder Lever for Honda VTX1800 02-08 GL1500 VALKYRIE 97-03 | eBay

Honda VTX1800 2002-2008. Honda GL1500C (VALKYRIE/ F6C) 1997-2003. No installation instruction. Easy install andNo Modification Needed.

www.ebay.com

Yea I saw those too. I was considering getting those and putting my “little” CNC, as my wife like to call it which takes up a quarter of my garage, to work on the covers. Not sure yet but thanks for the input.