Remove the seat by removing the two 6mm bolts (one on each side above the rear of your side covers) and the chrome 10mm tap on the rear, flip the seat over and you will see the two bolts that hold the seat together. (I usually put the bolts back into the seat so I will know where they are at when I want to put the pillon back on.)
There are some nice illustrations on this site as to the location of the side bolts if you search for them.
2005 VTX1800N. The site window doesn't show any antifreeze. Is there anyway to add without removal of the gas tank? Any place other than the radiator cap? (I have a very slow leak on radiator clamp, just need to tighten)
Been a happy owner of a 1300 R for the past decade but I finally decided I wanted more power and took the plunge on a used 1800. The VIN shows it's an 'F3' model. I'd read about F 1 and 2 but I don't think I've seen a 3 before. Anyone have the major differences off the top of their head...
2002 VTX 1800
Stock Muffler was scraping the ground when going over small bumps so I stopped and saw it was separated from the header pipes by a few inches. Gave it a small tug and it fell right off!
The lower bolts that bolt it to the frame were gone and one of the rubber bushings. Need to...
Hi guys I've looked on Google and it tells me that the VTX 1800 should get 200 miles out of a tank 40 to 45 mile per gallon is there anybody out there getting this cuz I'm sure not I'm getting about 20 and yeah I like two twist the throttle a little bit but even when I'm riding high gear just...