Honda VTX 1300 / VTX 1800 Motorcycles Forum banner

Bent Pipes Cuasing Major Decel Popping?

1381 Views 13 Replies 10 Participants Last post by  mscales
As some of you may know, some time ago I took my bike in to get serviced at the local shop because I felt the idle was inconsistent and it popped far to much for my liking (it was doing this even before I laid it down). Two months and $700 later still no fix.

There were a lot of different theories tossed around but ultimately they said the decel popping and inconsistent sounding idle were due to bent pipes. Now before I go and drop several hundred on a replacement set of Vance and Hines Bigshots I wanted to get the Cafe's suggestions on what could be causing my issues. The only thing Ive done since I bought the bike (used) is to remove the PAIR valve, which helped bring the bike back to where it was before the dealer got a hold of it (it was unbearable driving it home).

As ever Im looking forward to your help and getting my bike where it needs to be :patriot:
1 - 1 of 14 Posts
I'd try placing a one or two flat washer behind each acorn nut on the exhaust flange. In the past the acorn nut have been known to bottom out before becoming tight and then causing a leak. Careful not to break the stud off.
This could stop the popping.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.