Honda VTX 1300 / VTX 1800 Motorcycles Forum banner

Bike Doesn't start after taking it apart.

2760 Views 43 Replies 10 Participants Last post by  eagleinthewind

OK the bike was running ok. The problem I had was/is the choke would close all the way during long drives or short quick throttle burst. So after it closed when I come to a stop the bike would die unless I opened the choke or applied some throttle.

My Goal was to adjust the A/F screw, however not know where the screw was I pulled the bike apart assuming it was on the carb, which it is. I did not know that there was an adjusting screw down at the bottom of the air filter housing.

steps of what I did (remember bike ran before this)

Removed Seat
Removed Gas Tank (Petcock off)
removed air filter cover (saw fuel and oil in there. is that a concern?)
Removed air filter
Removed back of air filter housing from carb

No Adjustments made Re-assemble now

Attached the 2 air hoses at the bottom of the back of the air filter housing
Attached the back of the air filter housing to the carb (Carb looks like it could use a new o-ring)
put air filter back in
put the rubber gasket back in the air filter housing put cover back on
Put on gas tank
Attached electric from gas tank
put hose back in place at rear right of tank (if looking from the top of tank)
Put fuel line back on petcock and turn on petcock
Started bike

The bike ran very low idle for a few minutes then died. Now it won't start. does not seem to be getting fuel so I pulled the air filter to look at the carb I could smell the fuel could not see it spray though. (thought I would)
Put air filter back on.

now bike won't turn over like the battery is dead.

I am think about trying to jump the bike to see if it starts.

Does anyone have suggestion of what I can loook at or for?
See less See more
1 - 1 of 44 Posts
There is also the vent line on the right rear of the tank. I usually bolt down the tank and then remember. :)
1 - 1 of 44 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.