Honda VTX 1300 / VTX 1800 Motorcycles Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4,919 Posts
Discussion Starter · #1 ·
the 10mm bolt just turns... it won't come out WTF!#@$#[email protected]#!

I was able to push the box down enuff to get the tab out of the frame notch.

Completed the mod, put in the block off plates and started taking the pair valve out, but can't get to that hose behind the air box!!

What ideas do you all have for me?
 

·
Klaatu Barada Nikto
Joined
·
1,807 Posts
yank the hose off... its the big one
 

·
Registered
Joined
·
4,919 Posts
Discussion Starter · #3 ·
so from btw the engine on the other side, just yank the big hose off?
 

·
Registered
Joined
·
4,919 Posts
Discussion Starter · #5 ·
I yanked the hose off. Will cap it off from the inside of the box.

Thanks!
 

·
Registered
Joined
·
7,404 Posts
They put the stupid bolt inside a rubber grommet. Grab the housing in each side and yank it off.
 

·
Registered
Joined
·
31 Posts
I had the same problem with the 10mm bolt just spinning. Man I sure appreciate this forum and all the info provided.
 
1 - 7 of 7 Posts
Top