Errrggghhhhhh last night sucked....

1159 Views 1 Reply 2 Participants Last post by coley, Aug 6, 2006

Big-X

Discussion Starter · Aug 6, 2006

I had plans, big plans on getting my brakes on, installing and flushinh the lines, and riding. Hell, I didn't even get the brakes on.

Kept having o fix screwups.

I finally got so fustrated that I had just layed a tool down and could not find it. Instead of getting more pissed I turned off the light and went inside and watched a movie...I was pissed.

SO, Saturday I wake and go out...I still need to remove the pistons from the calipers but can't get them out. I fianlly got an ait pump and got the out, lubed them, and now my front brakes are installed and ready for fluid.

Have a little work to do with the clutch hndle and I should be done. The PCIII sould be here this week and the dyno should be Friday or Saturday.

I PRAY tomorrow goes as good as today!!

Save

1 - 1 of 2 Posts

coley

· #2 · Aug 6, 2006

Big-X said:
I finally got so fustrated that I had just layed a tool down and could not find it. Instead of getting more pissed I turned off the light and went inside and watched a movie...I was pissed.

I PRAY tomorrow goes as good as today!!

If it means anything....you did the right thing. Been there, maybe not with the bike, but with machinery. Not very much good comes from working while being upset. It's good to clear your head and start fresh another day. I'm sure you would be twice as pissed if you screwed up your paint job or somthing else! Good luck today....I'll be thinking of you.:choppersm

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month