Honda VTX 1300 / VTX 1800 Motorcycles Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I'm looking to change out my bars for something 8-10" higher. Is there a bundle or kit with all the wires and cables I would need to do this and if so, where? If not where's the best place to buy all this stuff. It's kinda hard to find everything on Amazon.
 

·
Super Moderator
Joined
·
10,303 Posts
There is not a kit you can buy. You need to cut, splice, solder, shrink wrap each wire. Search these forum for posts on the subject. Some are by me detailing what I did and how I also ran the wires internally when extending them. At the same time I also installed platinum braided stainless lines/cables.

G'day,

Vinish
 

·
Registered
Joined
·
659 Posts
Its not as hard as you think to cut/solder/shrink wrap/internal wire it all. I am in the process of doing it right now. Getting ready to start the left side soon as we get another 60-70 degree day (Girlfriend wont let me solder in the house for some reason:hmm2:). Make sure you take your time and label everything. Also make your cuts staggered, that way your not pulling a big wad of wires thru one tiny hole on the handlebars.
 
1 - 5 of 5 Posts
Top