Honda VTX 1300 / VTX 1800 Motorcycles Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi all,
Having issues tuning my '04 VTX1300C with Kuryakyn High Five Air Cleaner and Bub Jughuggers with quiet baffles, Completed SCAR mod and seems to run best with three shims, but have a dead spot about 1/3 Throttle and hold, starts sputtering really bad. Still have stock jets installed. Any suggestions?
:banghead:
 

·
Equito Passim
Joined
·
9,148 Posts
1/3 throttle is the needle/clip position.

Couple things:

What size washers are you using?
Cut the tit?
Cut the spring?


I'd personally recommend just breaking down and getting the FP Stage 3 kit and being done with it... you wont be sorry

-Gonz
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
I have three #4 from Radioshack, 2 washers hag same issue.
Tit was cut during SCAR mod about 3/32 long now.
Cut which spring? The needle spring?

And I have been looking really hard at the FP kit... ;)
Thanks for the reply.
 

·
Lady Rider
Joined
·
870 Posts
Has this been resolved? Bought hubby the hi five and haven't put it in yet and was wondering about the jetting.
 

·
Registered
Joined
·
6 Posts
soots

I just installed the kuryakyn mach 2 on my 2006 vtx 1300 c, do you have any issues with leg clearance?? I can hardly get to the brake pedel now.

Brad
 

·
Lady Rider
Joined
·
870 Posts
Hubby had leg clearance issues with the brake peg. He got hold of a guy that use to be here on the board and bought a brake peg extension. I think he paid 35.00 shipped. It's just right now. here's his link if you want to email him. He got right back to us and we had the part within 10 days. Good luck.

[email protected]
 
1 - 7 of 7 Posts
Top