Honda VTX 1300 / VTX 1800 Motorcycles Forum banner

Stem Bearing Installation Order

1K views 9 replies 7 participants last post by  toasted_3111979 
#1 ·
Ok.. been reading a lot but no luck finding this:

Just want to make sure that everything goes in this order
Please correct me if I'm wrong.
I am using the AllBall set which comes with seal, bearing and race

Lower TT
1. Dust seal
2. Bearing
and the race goes in the bottom of the neck

Upper TT
1. Race
2. Bearing
3. Dust seal
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top