A thread was posted close to a year ago now by me about getting some custom VTX parking signs made. Turns out the company that was going to do them for a tolerable cost backed out. Could not find a replacement vendor that would do them for less than right at $30.00 - $40.00. (too much)
Thread was located here:
Hince THIS new thread.
This little project was never forgotten but took me this long to find a vendor that would do this for any kind of reasonable cost.
Have found a vendor that will do the signs and I think I can get them to you for around $15.00. Will have to finalize that number, will depend on order size.
They will be made of Coroplast (indoor/outdoor material) at a 24 x 18 or 24 x 12 size.
Just wondered if there was still any interest?
I apologize for this taking so long but it has been an on and off the burner thing for the last 10-11 months.
atriot: :choppersm IN PGR-KewlMetal Risers - NC Switchblade 2UP-Paladin Highway Bars-Kury Iso GripsPair'd-Scar'd-Glen's A/F tool-Doug's Custom Edelbrock Filter-Seat Pin Mod- Webslinger Custom Speedometer-Glens Clutch Pull Relief-Glen's Gas Cap Hinge-Donut's Turnsignal Beeper- Stebel Horn (in Donut's custom mounting box)-Power Distribution Box-Kury Deep Dish Bezels-H4 Headlight bulb- Kury Swingwing passenger pegs &Retro driver pegs -Kermit Mod-Mondo (Handlebar wrap) mod-All Balls Bearings
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.